8
Please Do Not Return This Product To The Store.
Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the
Find a Dealer
section online at
www.wayne-dalton.com
Tools Needed:
NOTE
: If you have riveted track, skip
this step.
Vertical track must be cut to the proper
length prior to installation.
IMPORTANT:
DOORS ThAT ARE 7’-0”
OR 8’-0” IN hEIGhT DO NOT REquIRE
CuTTING ThE VERTICAL TRACk.
Determine the radius of your horizontal
track. using this measurement, refer
to the vertical track cutting chart to
determine the length of the vertical
track. Cut the track off at the TOP.
Now, two holes must be drilled into the
top of the cut vertical track. Refer to the
illustration shown for hole locations.
use a 5/16” drill bit.
Repeat for other vertical track.
To attach the bottom jamb bracket,
jB-2, locate the first set of quick install
features of the vertical track. Align
the slot in the jamb bracket with the
slot above the quick install features in
the vertical track. The long side of the
bracket is placed against the track.
fasten the jamb bracket finger tight,
using (1) 1/4”- 20 x 5/8” carriage bolt
and (1) 1/4”- 20 flange hex nut.
To attach the top jamb bracket, jB-3,
locate the third set of quick install
features of the vertical track. Align
the slot in the jamb bracket with the
slot above the quick install features in
the vertical track. The long side of the
bracket is placed against the track.
fasten the jamb bracket finger tight,
using (1) 1/4”- 20 x 5/8” carriage bolt
and (1) 1/4”- 20 flange hex nut.
Repeat for other vertical track.
1
Cutting vertical Track and
Installing Fully Adjustable jamb
brackets
1ST SET
3RD SET
fuLLy ADjuSTABLE
jAMB BRACkET
jAMB BRACkET
SLOT
(1) 1/4”- 20 X 5/8”
CARRIAGE BOLT
(1) 1/4”-20
fLANGE
hEX NuT
jAMB BRACkET
VERTICAL
TRACk
quICk INSTALL
fEATuRE
quICk INSTALL
fEATuRE
VERTICAL
TRACk
12”
12”
Horizontal
track
Stamped
radius
Tape Measure
hacksaw
Power Drill
5/16” Drill Bit
vertical Track Cutting Chart
Horizontal
Track Radius
Vertical Track Cut Length
10”, 12”
Door Height Minus 10”
14”
Door Height Minus 8”
3-1/2” LHR
Door Height Minus 15”
6-1/2” LHR
Door Height Minus 12”
Cut vertical
track here
Vertical Track Cut Length
1/2”
5/8”
5/16”
5/8”
