Door Arm Hookup
Align hole in the door arm with holes in drawbar operator bracket tabs, as shown. Insert
5/16” x 1-1/4” clevis pin, making sure hole in clevis pin is outside of second tab of drawbar
operator bracket. Insert hairpin cotter into clevis pin hole and spread hairpin cotter to secure
assembly, as shown.
Spread cotter pin
Clevis pin
Cotter
pin
Drawbar operator
bracket
Drawbar
operator
bracket tabs
5/16”x 1-1/4”
Clevis pin
Door arm
Inside Lock
Install the inside lock on the second section of the door. Secure the lock to the section with
(4) 1/4” - 20 x 11/16” self drilling screws. Square the lock assembly with the door section,
and align with the square hole in the vertical track. The inside lock should be spaced ap-
proximately 1/8” away from the section edge.
IMPORTANT:
INSIDE LOCK(S) MUST BE REMOVED OR MADE INOPERATIVE IN THE UN-
LOCKED POSITION IF AN OPERATOR IS INSTALLED ON THIS DOOR.
Inside lock
End cap
1/4”-20 x 11/16”
Self drilling screws
Square hole in
vertical track
Lock
(Second)
section
1/8”
Pull Down Rope
WARNING
DO NOT INSTALL PULL DOWN ROPE ON DOORS WITH OPERATORS.
CHILDREN MAY BECOME ENTANGLED IN THE ROPE CAUSING SEVERE OR
FATAL INJURY.
Measure and mark the jamb approximately 48” to 50” (1220 to 1270 mm) from floor on the
right or left side of jamb. Drill 1/8” pilot hole for no. 6 screw eye. Tie the pull down rope to the
no. 6 screw eye and to the bottom corner bracket, as shown.
Bottom bracket
Pull rope
No. 6 Screw eye
Pull rope
48” to 50”
From floor
18
Optional Installation
