9
1. Click on the
Add Module
icon in
the toolbar. A message window
will appear and ask you to press the
button on the module to add.
2. Press and release the PRogRAM
button on the Z-Wave
®
module. If
the module is successfully added
you will be prompted to give it a
name. Providing meaningful names
for the modules makes network
setup and control much easier. The
new module will appear in the upper
left part of the plan view in the
window. You may move these icons
around by clicking and dragging
them into open spaces or into rooms
(see Drawing a Floor Plan, page 12).
Repeat this procedure if the module
failed to be included.
To view the name of a Z-Wave
®
module in the plan window, hover
over its icon with your mouse and
the name will pop up automatically.
If the module does not have a name,
it will be named ‘unnamed’ and the
internal Z-Wave
®
node number
will follow in brackets.
NoTe:
For your security, the USB
Z-Wave
®
Adapter must be within 3
feet of the Z-Wave
®
module to be
added. If this is not possible, please
set up your network with a portable
remote controller and then copy
this information to the USB adapter
(See “Joining Houseport
®
to existing
Networks”, page 23).
3. Repeat Steps 1 and 2 for each
module you wish to add to the
network.
NoTe:
Please see the User Manual or Instruction
Manual for the specific Z-Wave
®
module being
programmed to locate the PRogRAM button and
for specific programming information. To add
a new controller as a secondary controller to
the network, please see the section “Adding a
Controller to the Network” page 25.
TIP:
If the Z-Wave
®
module fails to be included in
the network it may have previously been used in
another network and needs to be reset. Press the
ReMoVe DeVICe button in Houseport
®
and then
press and release the PRogRAM button on the
Z-Wave
®
module.
TIP:
The process of adding modules to a network
is often referred to as INCLUSIoN.
Adding Modules to the Network
Installation/Setup
ON/O
FF
P
RO
G./D
IM
Press-and-Release
PRogRAM button on
module
