Dosing Device Foamdos V6
Index: 01
Date modified: 26/08/2019
OI No.: BA DW 025-00 Foamdos V6 EN.DOCX
Page 16 of 37
4.5
Electrical installation
General notices
ATTENTION!
The electronic components in the devices are sensitive to electrostatic discharges. The
generally accepted safety precautions for ESD-sensitive devices must be observed when
handling the devices.
The following applies, in particular:
Plug-in connectors must only be connected or removed when the power has been deactivated.
Before touching electrical components inside the device, the person handling it must electrostatically
discharge himself for at least 5 seconds. For example, by touching an earthed system part or by wearing
an ESD antistatic wrist strap connected to an earth wire.
4.5.1
Open/ close the housing
The housing need
not
be opened for electrical connection.
Open housing
1. Unlock the locking knob (A) with a screwdriver.
2. Press down on both recessed grips (B) until the housing
snaps open.
3. Swivel open the cover.
Close the housing
1. Close cover. The recessed grips (B) must snap shut.
2. Lock the locking knob (A) with a screwdriver.
4.5.2
Establish electrical connection
1. Ensure that the isolated ground socket is earthed.
2. Switch off the mains switch on the device.
3. Connect the button plate’s plug to the device.
4. Insert the mains plug into the isolated ground socket.
Figure 11, Open control housing
B
B
A
