Dosing Device Foamdos V6
Index: 01
Date modified: 30/08/2019
OI No.: BA DW 025-00 Foamdos V6 EN.DOCX
Page 29 of 37
8
Decommissioning – Storage – Disposal
8.1
General
In the event of decommissioning, the devices must be emptied completely or protected against frost!
Disposal of used parts and operating materials
Thoroughly clean any dismantled, contaminated parts prior to disposal.
Used parts and operating materials must be disposed of according to the regulations applicable at the site of
operation or they must be recycled. If operating materials are subject to special regulations, please observe
the corresponding information on the packaging. If in doubt, information may be obtained from the institution
responsible for disposal at your location.
If this is not possible, dispose as hazardous waste.
8.2
Decommissioning
Switch off the device at the mains switch for decommissioning.
Decommissioning for more than 30 days
Remove the suction lance from the canister.
Close the canister.
Flush the foam line with water. (Press the “Flush” push button).
Empty the suction line and the foam concentrate dosing valve and flush them
All components must be stored dry and cleaned.
Remove the roller carrier of the peristaltic pump to prevent damage to the dosing hose. Procedure
see
Chapter
Open drain valve (accessory)
ATTENTION!
When recommissioning, it is essential that the instructions in the “Commissioning”
chapter are observed and the points contained in the commissioning protocol are
implemented.
