Granudos 45/100-CPR Touch XL + Touch + S5
Dosing unit
Index: 02
Date modified: 06/06/2019
OI No.: BA SW 003-02 Granudos 45-100 CPR Touch+Touch+S5-Dosiereinheit EN.docx Page 23 of 58
4
Installation
4.1
Select the installation site
The following should be observed in regard to the installation site:
1.
A freely accessible assembly location should be selected to facilitate operations and
subsequent maintenance tasks.
2.
Meet the dimensions for the floor drain and the temperature specifications for the
ambient air and medium in accordance with
Section 3.4 Technical Data.
No flammable
vapours, dust or gases may be present in the immediate vicinity of the device.
3.
The device must not be exposed to the elements. It may not be installed outdoors. The
device must be protected from frost and direct sunlight.
4.
An electricity grid connection and a duct connection must be available. Depending on
the device configuration, an Internet connection may also be required.
5.
The operating room must not be used as a recreational space. (max. 2 hours per day),
consult the locally applicable accident prevention regulations (Germany BGR-GUV-R
108).
6.
It must be possible to vent and aerate technical areas so that hazardous substances do
not occur in health-hazardous concentrations (from accident prevention regulations
BGR-GUV-R 108).
If these conditions are met, there should be no problems with the
dosing. However, a strong air flow at the dosing device must be avoided.
7.
Collecting basins must be available for use with the chemical canisters and the
buffertank, if applicable.
8.
It must comply with the accident prevention regulations and should not be accessible to
unauthorised persons. A separate storage space must be available for the chemicals.
4.2
Installation instructions / installation suggestion
Remove transport safety devices
Attach warning and notice signs in accordance with the locally applicable accident
prevention regulations (Germany: BGR-GUV-R 108) at the designated positions.