Operation manual Soldos - SL (04-09) page 7 of 18
30
-1,0
ø140
ø126
4,5
Sichtfläche
Punkt - Schweißen
1
80
2,5
ø125
ø100
4. Assembly of the nozzle
For the installation of the nozzle and the covering screen, a borehole (100
mm) has to be done through the wall of the room (see picture). The
grommet/ mounting sleeve has to be glued-in diffusion resistant, in order
that the cover screen of the nozzle rests on the cabin surface with the
sealing. For the final assembly, the hose lines are directed from the
dosing unit through the mounting sleeve and connected on the hose
connections of the two-component jet nozzle. Now the cover screen is put
onto the mounting sleeve and fixed with the incl. screws.
When connecting the hose connections, please consider that the
compressed air piping and the brine dosing tube are not interchanged.
The difference between both hoses helps you here. For the compressed
air piping, a PE hose is used – with inside diameter of 6 mm and wall
thickness of 1 mm. The saline dosing connection consists of PTFE material
– with inside diameter of 4 mm and wall thickness of 1 mm. Therefore,
the dosing unit as well as the nozzle is provided by the fitting hose
connectors.
We recommend you to pass the dosing pipes by protective
material (insulation). Please consider that the lines are flexible
(backwards), for a possible dismounting of the nozzle.
Grommet/ mounting sleeve cover screen
