UP35-4481N26000-02/15
– REV.B1
Page 54 / 63
8
Normal Operation / Production Cycle
DANGER
+
Due to the risk of hand or finger injury, never try to reach into the machine before having
assured that the machine is disconnected from the air supply. Disconnect the air supply
before changing the safety guard, the adapter and the dies.
CAUTION
+
The pneumatic Parallel Crimp Machine UP 35 may only be set up and operated in perfect
technical condition, observing all the safety regulations and considering any possible
dangers.
+
The crimp machine is only allowed to be used with mounted dies, die adapter and the
suitable safety guard. Pay attention to the correct assignment of adapter to safety guard.
+
Before commissioning the machine, it is always important to check whether all safety
devices, especially the safety guards and die adapter, are installed and are functioning
correctly.
+
When working with the pneumatic Parallel Crimp Machine UP 35, do not wear loose
clothing, jewellery or long, loose hair that can get caught in the pneumatic Parallel Crimp
Machine UP 35.
+
Work with caution.
+
In cases of a machine malfunction, production must be stopped and the malfunction must
be fixed before continuing work with the machine.
+
Only one person is allowed to work on or with the machine at a time.
+
Only trained personal are allowed to work on or with the machine.
+
Assure free access to the operating elements of the machine, especially the foot pedal
and the release button. In the case of imminent danger immediately press the release
button. The release button must be within the direct reach of the operator. It must not be
covered.
+
It is only allowed to work with the specified air pressure.
ATTENTION
+
Position the pneumatic Parallel Crimp Machines UP 35 on a flat surface and assure the
stability of the machine. Ensure that the table or bench is stable enough to support the
machine in normal use. During the utilization the machine has to be placed on a table or
a similar flat surface.
+
Place the foot pedal on the floor. No other place is allowed. The foot pedal must be
movable, so that the operator has the possibility to change his position for ergonomic and
production needs. Do not lay the foot pedal in aisles or walkways.
+
Place the tubes on the floor or out of the way so that they do not cause a trip hazard.
Crimp process without locator:
1. Insert the crimp contact in the die profile. Please pay attention to the correct profile
assignment and to the correct positioning within the crimp profile!
2. Insert the wire/cable which is stripped acc. to the specifications and position it for
crimping.
3. Press the foot pedal to start the crimp process.
4. Keep the foot pedal pressed until the crimp cycle is finished.
5. Remove crimped contact.
