8
F 5
- Drive setting
Platter bearing
5. Drive settings
The sub-chassis drive and the bearing setting are
already set properly at the factory.
However, for individual adjustments it is possible to
customize the following:
a.) Adjusting the platter bearing:
It is possible to adjust the ratio of the platter bearing
between the bearing on the steel ball or the magnetic
pillow by adjusting the screw M5 on the bottom side of
the device by loosening the counter nut.
You can individually adjust the distance between the
bottom side of the platter and the platter by tightening
or loosening the screw.
This may be necessary after several years because of
the decreasing magnetic effect (see fig.
F 5
- platter
bearing).