Then dry thoroughly. Ensure the interlock area is free of
food particles
FOR A QUICK WASH UP
Between processing tasks, pour in some water into the jar,
press and hold the PULSE button for several seconds for
quick cleaning.
KNEADING/MIXING
1.
Firstly assemble the driving shaft into the motor base, make sure it is clipped into position.
2.
Place the jar on the motor base and turn it clockwise until it locks into position. Make sure it is
assembled in place correctly, otherwise the appliance will not operate.
3.
Insert the plastic blade into the driving shaft in the jar securely.
4.
Measure the flour with measuring cup and put them into the jar. The maximum quantity of flour
is 500g.
5.
Place the lid onto the jar and turn it clockwise until the tab of the lid clicks into slot in the jar
handle. Make sure it is locked in position correctly, otherwise the appliance will not operate.
6.
Add one tablespoon oil into the appliance from the feeding funnel. Connect the appliance to
power supply. Press down the HI button.
7.
Then add water (the maximum water quantity is 300g) with measuring cup from the feeding
funnel slowly within 20s.
8.
The proportion of the flour and water is 10:6. Make sure the quantity of the water shall not be
more than the maximum specified water quantity.
Note:
Add some more water if the processing speed slows down during operating so as to make
the motor run smoothly, otherwise the motor may be damaged. During kneading/mixing, to avoid
shaking, press the lid with one hand, and the other hand is holding the handle.
9.
Stop the process by pressing the OFF button as soon as the pastry starts to form a ball.
CAUTION: The total operation time is not more than 90 seconds.
10.
Unplug the appliance, detach the cover, firstly remove the plastic blade, then remove the dough.
CLEANING
1.
Disconnect the power supply before cleaning.
2.
Empty the jar and remove the lid, the plastic blade,
pusher, then immerse them in water and clean them with
a damp cloth or soft brush.
3.
Wipe the outside of base with a damp cloth. Never
immerse the motor base in water as electric shock is
possible to occur. Then dry thoroughly. Ensure the
interlock area is free of food particles.
