WAYS OF THREADING
Threading the upper thread as follow:
1. Place full cotton reel on to the large recessed spindle at the top/rear of the
machine with the thread to the rear. Push the reel cover over the spindle so that
the reel cannot come off.
2. Loop the thread around the outside of thread guide1.
3. Guide the thread into groove2 aligned with guide1 and pull\l up towards the
chrome take up lever3.
4. Feed the thread through the hole in the chrome lever and pull straight down
towards the needle.
5. Feed the thread through the hole in the needle holder.
6. Feed the thread through the eye of the needle.
Caution: When threading the sewing machine make sure that the” power off/speed
switch” is in the OFF position and follow the steps1-6 below. Turn hand wheel counter
clockwise until the needle is in the highest position.
REPLACING THE BOBBIN
1. Remove bobbin cover and take out the empty bobbin (Fig.1).
2. Place the bobbin in the bobbin case with the thread unwinding in a clockwise
direction. Leaving about 10cm of thread extended out from the bobbin case
(Fig.2).
(Fig.2).
Summary of Contents for SW45
Page 2: ......
Page 5: ...NAME OF PARTS ...
