5
ASSEMBLY
Step 1: Assembling roof frame
●
Lay out the roof frame parts as shown below (fig. 1).
1
NOTE:
●
The five connectors are different and individually
numbered. When using them, ensure the welded
socket for the cross rail is below the bend (fig. 2).
2
7
Welded socket
8
9
10
11
●
Assemble the center section of the roof using the shoulder cross rails (4),
3-way peak connectors (10) and 4-way peak connector (11). Insert the
rafter poles (5) into the connectors afterwards .Connect rafter poles(5) with
3
10
11
10
5
5
4
4
5
5
5
5
●
Attach the shoulder cross rails (4) to the 3-way side connectors (7, 8) and
4-way side connectors (9). Insert the connectors (7, 8, 9) into the rafter
poles (5) to complete the assembly of the roof (fig. 4).
4
8
4
7
9
7
8
9
NOTE:
●
Be sure that all tubes are fully inserted. Use a rubber
mallet if necessary.
●
When using the connectors, be sure to remove the
protective caps first.
Step 2: Attaching legs
●
Assemble the legs (fig. 5).
Leg type
Qty
Connect to
Corner legs
4
Upright pole (1),
Bent corner leg (3)
Center Legs
2
Upright pole (1),
Center extension tube (2)
5
1
2
3
●
Insert one assembled center leg into the 4-way side connector (9) .
6
Insert the corner legs into the corresponding side connectors (7, 8) (fig. 6).
8
1
7
2
3
3
4
5
7
8
10
9
10
8
7
5
5
5
9
11
5
5
15
4
4
16
4
4
4
4
1
2
1
3
3
1
2
3
3-way peak connectors(10) and 4-way peak connector (11) with fittings(15,
16). (fig. 3).
4
4
4
4
4
11
1
●
Repeat the same procedure on the opposite side. (fig. 7).
7
1
8
3
3
1
9
7
2
1
1
3
3
1
1
