8
ASSEMBLY
19
Tube sleeve
19
Bottom cross rail (6)
Caution!
●
If small adjustments are needed, two people should
pull the roof tarp (19) from the same side so that it
does not twist.
●
loosen the bottom cross rails (6) from the frame. Slide the cross bottom
rails (6) through the tube sleeves on one side of the roof tarp (19).
Re-assemble the clamps (12,13)and fitting (16, 17, 18) and tighten
●
Make sure the cross rails (6) are level and horizontal.
20
●
Repeat the same procedure for the opposite side of the roof tarp (19).
●
Check and make sure all the bottom cross rails (6) are level and
horizontal, and are of the same height from the ground.
●
Tighten all the nuts and bolts at this stage.
●
Fasten the black straps at the four corners with the ratchet tie-down (22).
For details, see the corresponding instructions on page 7.
●
Now the shed is ready for use.
Caution!
●
Check and tighten the bottom cross rails (6) and
ratchets (22) monthly to ensure that the roof tarp
(19) is tight and safe.
●
When disassembling the shed, press the
spring-loaded bar and open the ratchet handle
completely to pull out the strap (fig. 21).
21
Spring-loaded bar
18
17
12
Tube sleeve
inside tube sleeve
16 bottom cross rail (6)
18
16
17
13
slightly (fig. 20).
