7. The moon phase is reliant on the date setting and will display the closest
phase for that date from new moon, first quarter, full moon and last quarter
phases.
8. If no button is pressed for longer than 8 seconds, the device will return to the
standard display.
4. Alarm setting.
1. Hold “Alarm” for 2 seconds to set.
2. Setting order: hour
→
minute
→
exit.
3. The setting will flash to signal awaiting input.
4. Press “Alarm” to confirm and to go to the next setting.
5. Press “UP” once to go forward a step; hold for 2 seconds to cycle through at 8
steps per second speed.
6. Press “DOWN” once to go back a step; hold for 2 seconds to cycle back at 8
step per second speed.
7. If no button is pressed for longer than 8 seconds, the device will return to the
standard display.
5. Temperature alarm setting
1. Hold “Alert” for 2 seconds to set.
2. Setting order: upper limit
→
lower limit
→
exit.
3. Press “CHANNEL” to change setting.
4. The maximum upper limit is +70
℃
and lower limit is -50
℃
.
5. The setting will flash to signal awaiting input.
6. Press “Alert” to confirm and to go to the next setting.
7. Press “UP” once to go forward a step; hold for 2 seconds to cycle through at 8
steps per second speed.
8. Press “DOWN” once to go back a step; hold for 2 seconds to cycle back at 8
step per second speed.
9. If no button is pressed for longer than 8 seconds, the device will return to the
standard display.
10. Alert is on after setting.
Ⅳ
. Functions
1. Radio Frequency (RF) receiving function
1. The device enters receiving mode for 2 minutes automatically when battery is
inserted.
2. Hold “Channel” for 2 seconds to cancel receiving on the current channel.
3. If the channel has not received signal for 35 minutes, the out door display will
show “--.-“.
4. Temperature and humidity will be shown again once reconnection has been
made.
2. Alarm:
1. The alarm sounds for 2 minutes at a time in the below pattern:
a. 0-10 seconds: beeps once each second;
b. 10-20 seconds: beeps twice each second;
c. 20-30 seconds: beeps four times each second;
d. after 30 seconds: constant sounding.
2. When alarm sounds, press “Snooze”
to set alarm back for 5 minutes, press
any other button to switch off permanently.
3. When in Snooze state, the alarm will sound again 5 minutes later.
