55 |
P a g e
RECESS/INSIDE FIT MOUNT INSTALLATION WITH
L-FRAME
1.
ASSEMBLE FRAMES
•
See relevant frame assembly pages
2.
PLACE FRAME IN OPENING
•
The top part of the frame is indicated by a greater amount of distance from the
top of the top hinge to the edge of the frame. The label will indicate left and right
side.
3.
FASTEN FRAME
•
Drill 10mm holes though the first layer and in line with the top of each frame
hinge.
•
Insert a screw in both the left and right top side frame holes. Centre the frame in
the opening, then drill the screws into the jambs. If the screw is not in enough, the
opening will be smaller than ordered. If the screw is in too far, the opening will be
larger than ordered.
4.
HANG PANELS
•
With upper and lower hinge pins only.
5.
SQUARE/LEVEL PANELS TO THE OPENING
•
Move bottom frame left or right until the panels are level. If this does not work,
then:
•
Move left frame up or down until the panels are level. If this does not work, then:
•
Move right frame up or down until the panels are level.
•
When the panels are level within the frame, hold bottom frame in position and
place a screw in the middle bottom frame hole.
6.
FASTEN REMAINING SCREWS
•
Insert screws in the remaining holes and check to ensure panels are level after
every screw has been drilled into position.
7.
INSTALL MAGNETS AND PLATES OR RAMPS (if applicable)
•
See previous pages for instructions.
8.
CAP INSTALLATION HOLES
•
Once all screws have been installed and panels checked for levelness, cap all
holes with the provided
button plugs.
9.
CLOSE ANY GAPS
•
With either L-Frame
Cover Strip, which is
glued to the front face
of the frame, or with
caulking.
Summary of Contents for Eclipse Shutters
