7
http://support.weathermatic.com
Edit Zone Flow Settings:
Here you will see a chart containing a list of all the zones
available on the controller. These settings give you the
ability to address each zone. The zone location in column 2
will display the zone names you provided in the “Zone Run
Times” on the “Programming” section of the Main page. If
you have not named your zones, go back to the Main page
and click “Edit Zone Run Times” within the “Zone Run Times”
section. Once named, click “Save” and return to editing the
Zone Flow Settings.
1.
The Zone Flow Settings chart will have columns for both
a Running Average and a Current Average of flow from
each zone. If you see 0.0GPM in these columns, flow has
not been learned.
SmartLink Network Global Flow Settings, Zone Flow Settings and Operation 4.0
Learning Flow for the First Time:
a. Once the “Flow Settings” have been applied, run
through a complete program cycle. You can run
a manual cycle or schedule a runtime to avoid
watering during restricted times. Make sure though
that every zone has run.
b. “Current Average” is calculated and viewable
immediately after a program cycle is run. To
populate the chart with that data you will need
to click “Receive” on the top right of the main
controller programming page.
c. “Running Average” is calculated after enough data
has been accumulated. We recommend 3 to 5
program cycles for the most accurate number. The
column will only populate with flow data during the
Aircard’s automatic nightly communication with the
network. It cannot be populated manually.
