35
Figure 19. Adjusting Operating Limits
4.9 SELECTING LOCAL OR REMOTE OPERATION
Once the load has been connected and the load configuration has been chosen,
the 900 EX is ready to run. At this point, the unit is in Local/Independent Mode
operation by default. If ROS is running Remote Operation of each channel, it can
be initiated; otherwise, the unit must be operated in Local mode via the front
panel controls.
If local operation is planned, Begin Session must be pressed first and then select
a Control Mode (i.e., Voltage, Current, Power, or Resistance Control). Local
operation is described further below.
4.9.1 LOCAL OPERATION
After a session has begun in local operation, all control and adjustment is done on
the HMI screen.
• A Control Mode must be selected to start a test.
• After the test has begun, the control setting may be adjusted and the Control
Mode may be changed while running the test, as described below.
• Once the test is completed, select Standby Mode by pressing the STOP button on
the HMI screen to open the contactors and internally isolate the load.
Summary of Contents for 900EX
