IMPORTANT:
z
Check the oil level before each use. Add oil if needed. Fill to the full line on the dipstick.
z
Change the oil after every 25 hours of operation or each season. You may need to change the oil
more often under dusty, dirty conditions. See “TO CHANGE ENGINE OIL” in the Maintenance
section of this manual.
ADD PETROL
z
Fill fuel tank to the bottom of the tank filler neck. Do not overfill. Use fresh, clean, regular unleaded
petrol. Do not mix oil with petrol. Purchase fuel in quantities that can be used within 30 days to
assure fuel freshness.
CAUTION:
Wipe off any spilled oil or fuel. Do not store, spill or use petrol near an open flame.
CAUTION
: To avoid engine problems, the fuel system should be emptied before being stored for 30 days
or more. Empty the fuel tank, start the engine and let it run until the fuel lines and carburettor are empty.
Use fresh fuel for your next use of the machine. See Storage Instructions for additional information.
Never use engine or carburettor cleaner products in the fuel tank or permanent damage may occur.
START THE ENGINE
To start the engine, first make sure that the spark plug is tightened and that the machine is filled with
sufficient oil and petrol.
NOTE:
Due to the protective coating on the engine, a small amount of smoke may be present during the
initial use of the product and should be considered normal.
Press the primer bulb 3 times to allow fuel into the engine (for the first use, press 5 times).
Hold the Operator Presence Control bar down to the handle and pull the starter handle quickly.
Do not allow the starter rope to snap back.
STOP THE ENGINE
z
To stop engine, release the Operator Presence Control bar.
z
Disconnect the spark plug cap if the lawnmower is to be left unattended.
FUEL TANK CAP
5
