ASSEMBLE HANDLE
Fit the Lower Handle to the frame of the lawnmower.
Insert 1x Square Neck Bolt M8x30 in the lower hole of the handle and frame from the outside.
Once through, add the Flat Washer and Small Triangle Knob with M8 Hex Nut, tighten until they are
secure.
Enter Hex Bolt M8x16 into the second lower handle fixing and frame hole from the outside.
Once through, add Lock Nut M8/8.8 and tighten.
Fit the Top Handle to the Lower Handle.
There are two holes in the Upper Handle, insert the Carriage Bolt M8x50 from the inside through the
Lower Handle and your selected hole in the Upper Handle to assemble the handle at your chosen
height.
Once through, fit a Flat Washer and Large Triangle Knob with an M8 Hex Nut, tighten until they are
secure.
INSTALL ATTACHMENTS
The mower has three different operating modes.
1. Collecting:
Fit the grassbox by lifting the rear flap on the mower and hook the front of the box to the shaft on the
mower.
Lower the flap to lock the grassbox in position.
When the box is full, the grass will be visible through the viewing window in the top of the box.
Stop the engine before emptying the grassbox.
2. Rear Discharge:
With the grassbox removed and the rear flap in the down position, the mower will cut and discharge the
grass from the rear of the machine.
3. Mulching:
Fit the mulch plug to the rear discharge opening of the mower and close the rear flap.
Remove the side discharge cover and close side cover.
The mower will now recycle the chopped grass into the lawn surface.
To mulch efficiently only cut one third of the length of the grass.
4. Side Discharge
Please install the side discharge cover, as per the images below.
