10
INSTRUCTION MANUAL
5.
To attach the upper handlebar, first remove the two handlebar knobs and washers. Please note that these
have a two-phase thread, to stop the knobs was coming off the bolt accidently and being damaged.
NOTE: The Recoil rope guide attached to the upper handle, should be on your right side.
6.
Position the handlebar over the lower handles just below the lower handlebar, aligning the holes in the
upper handle with those in the lower handles. Insert the two locking knob bolts through the lower handle,
then through the upper handle holes.
7.
Then attach the handlebar knobs on the outer side of the upper handle and secure until tight.
CABLE TIDY
1.
Place the cable tidy over the handle assebly and house the cables into the tidy.
ASSEMBLY
Remove the machine and contents from the carton. Be sure the carton is empty before discarding.
If you require any assistance with regards to the contents of the machine, contact us:
Tel: 01793 333212 - Mon – Fri 8.00am – 5.30pm (excl. Bank Holidays)
Email: customerservice@webbgardenpower.co.uk
IMPORTANT INFORMATION
NOTE: This product is a 4-stroke engine powered machine.
The engine MUST be filled with recommended 4-stroke SAE30 or 10W/30 air cooled lawnmower engine oil
BEFORE starting. Fresh unleaded petrol must be used in this unit. DO NOT use Ethanol based fuels. DO NOT
mix oil with fuel.
WARNING
Stop the engine and unplug the spark plug before any repairs or maintenance operations.
DO NOT attempt to start this machine without it first being FULLY assembled.
DO NOT attempt to start this mower without first adding 4-stroke SAE30 or 10W/30 air cooled lawnmower
engine oil to the engine.
HANDLES
1.
To attach the lower handle, first remove the two lower handlebar knobs and washers. Please note that the
bolts have a two-phase thread, to stop the knobs was coming off the bolt accidently and being damaged.
2.
Place the lower handle in position by aligning the lower handle with the outer side of the metal mounting
plates located at the back of the mower deck.
3.
Once in position, insert the bolt on each side through the mounting plate and then through the lower
handle.
4.
Once the bolts are loosely in position, attach the washer and lower handlebar locking knobs onto the
outer side of the lower handles and secure until tight.
