13
HEIGHT OF CUT
To adjust the height of cut, the machine has been supplied with a single lever, located at the right rear wheel.
Adjusting the height of cut should only be undertaken when the engine is off, and the blade has come to a
complete standstill.
To adjust the height of cut, grab the height of cut lever and push it away from the gauge (1) and then lift or
lower the lever to the required height of cut (2).
Moving the lever forward will lower the height of cut (Min. 25mm). Moving the lever back, will raise the height
of cut (Max. 75mm)
SIDE DISCHARGE CHUTE
NOTE : When using the side discharge function. Remove the grass collector and plug the mulch plug into the
rear of the machine.
1.
Unlock the side discharge cover and lift. Hook in the side discharge chute.
2.
Allow the side discharge cover to secure onto the side discharge chute into position.
MULCH PLUG
NOTE: Mulching stops collection of grass into the rear collector.
You will find the mulch plug loose in the carton or fitted to the machine. If the mulch plug is not located in the
carton, lift the grass collector flap at the rear of the machine and remove the mulch plug.
GRASS COLLECTOR
1.
Left the grass collector flap up, so that it opens past the handle assembly. Hold in position and place the
grass collector hooks over the springs and place into position.
2.
Lower the grass collector flap to sit onto the grass collector.
RECOIL STARTER HANDLE
1.
To ease starting of the machine, the recoil starter handle can be housed on the handle assembly.
2.
To house it correctly, pull the OPC/Brake lever towards the main handle. Do not let go.
3.
Now grab the recoil starter handle and slowly lift it towards the housing. There will be some resistance
and do not pull too hard. Wrap the Starter rope through the housing and seat the recoil starter housing.
4.
You can now release the OPC/Brake lever.
