TILTING THE MOTOR HEAD
When trimming at high or low level, the motor head can be tilted at an angle of 90
o
to -45
o
in 45
o
increments.
1.
Remove the battery from the handle.
2.
Press the Head Adjuster button.
3.
Tilt motor head in required direction.
4.
Release button and allow motor head to engage.
5.
Place the battery on to the handle, with an audible click.
EXTENDING THE TELESCOPIC SHAFT
For cutting at high and low heights, the telescopic shaft can be extended by up to 60cm.
1.
Remove the battery from the handle
2.
Loosen the Collar (11), extend the telescopic shaft (2) to the require length, and tighten
the Collar (11) again.
3.
Place the battery on to the handle, with an audible click.
WARNING
To guard against injury, observe the following:
• Read this instruction manual before using. Save the instruction manual.
• Check the hedge for foreign objects, such as wire or fences before each use.
• Keep hands on handles. Don’t overreach.
• Do not use under wet conditions.
CAUTION
Blade may coast after turning off.
DANGER
Keep hands away from blades.
MOTOR HEAD
ADJUSTER
BUTTON
CLEANING & MAINTENANCE
DANGER
Prior to conducting maintenance or cleaning: Remove the battery from the machine.
The trimmer blade could still move after being switched off! Always remove battery before
performing any work on the trimmer!
Note: Clean unit immediately after every use. Hedge debris when dry is very hard and are very
difficult to remove.
BEFORE EACH USE
What?
How?
Check the battery, charger and machine for
damage.
Conduct a visual inspection and have any
faulty component replaced.
IF NECESSARY
What?
How?
Cleaning the device
Use a clean soft brush or damp cloth.
Lubricate blades
With a rust preventative solution or light
machine oil
MAINTENANCE
A plastic blade cover is supplied with your trimmer for storing. Remove the battery and slip the
hedge trimmer blade into the cover.
WARNING
Remove battery before servicing, cleaning or removing material from the gardening appliance.
The cutting blades are made from high quality, hardened steel and with normal usage, they
will not require sharpening. However, if you accidentally hit a wire fence (figure 9), stones,
glass or other hard objects, you may put a nick in the blade. There is no need to remove this
nick as long as it does not interfere with the movement of the blade. If it does interfere,
remove the battery and have an approved service dealer, use a fine-toothed file or sharpening
stone to remove the nick. If you drop the trimmer, carefully inspect it for damage. If the blade
is bent, housing cracked, or handles broken or if you see any other condition that may affect
the trimmer’s operation, contact your local approved service dealer for repairs before putting
it back into use.
Fertilisers and other garden chemicals contain agents which greatly accelerate the corrosion
of metals. Do not store the unit on or adjacent to fertilisers or chemicals.
With the battery removed, use only mild soap and a damp cloth to clean the unit. Never let
any liquid get inside the unit; never immerse any part of the unit into a liquid. Prevent the
blades from rusting by applying a film of light machine oil after cleaning.
STORAGE & TRANSPORTATION
STORAGE
Store the tool in a dry and well-ventilated place.
TRANSPORTATION
Always remove the battery from the machine and ensure the blade guard is securely place over
the blade assembly, when transporting the product.
INSTRUCTION MANUAL
Summary of Contents for WEV20PHT
Page 19: ...Notes ...
Page 20: ...PARTS DIAGRAM ...
Page 23: ...Notes ...
Page 30: ...Webb Lawnmowers Murdock Road Dorcan Swindon Wiltshire SN3 5HY ...
