11
Maintenance and repair work
Only use
original Weber MT spare parts
to ensure reliable and safe operation for
maintenance or repair work.
Adjusting tasks, maintenance tasks, and inspection tasks must be carried out on schedule
as specified in this operating and maintenance manual. These activities should only be
executed by instructed personnel.
For repair, maintenance, or inspection work the engine of the tamper must be
disconnected from the battery.
For maintenance and repair tasks the tamper must be placed on a level and
stable substrate and must be secured from rolling off or tipping over.
Ensure that no hazard is caused by components or assemblies while work is in progress.
Do not position yourself or work under suspended loads.
Operation
Prior to starting work the owner of the tamper must be familiar with the work environment.
The work environment includes obstacles in the work and traffic area, the bearing capacity
of the ground, as well as the necessary safeguarding of the construction site in the area
adjacent to public traffic; and it includes compliance with traffic regulations.
The tamper should only be operated when the protective fixtures are mounted.
The protective fixtures must all be in functional condition.
At least once per shift the tamper must be checked for apparent defects. If there
are apparent defects then operation of the tamper must be stopped immediately and
the responsible person must be informed. Prior to restarting, tamper malfunctions that
have occurred must be corrected.
If lubricating oils come into contact with skin, they can cause skin cancer. Upon contact
with the skin, clean affected skin with suitable cleaning agent without delay.
