Chapter 7
Adjustment and initial operation
40002674 BTA Geset 117
Version: 15.01.14
page 34 of 59
GB
Adjustment and initial operation
The labeling system has to be re-adjusted at initial operation or at a product change . The
adjustments comprise two functions, operation of the controller (refer to manual of the
labeler) and mechanical setup of the assembly groups (explained in the following).
In following adjustment table all required working steps are listed including adjustments of
optional assembly groups which can be skipped if nonexistent. Experienced operators
may use the adjustment tables later on as a checklist.
Requirements
¥
Control about product transport.
¥
One or more sample products.
¥
Labeling system and if so ²turning plate are connected to power and. Triggering
of the labeling system is possible by product sensor or I/O-interface.
*
*²Only if system has the appropriate features.
Instruction
Please put the labeling system Geset 117 into operation as follows.
Step
Procedure
1
If there are already exist notes of the „adjustment values“
for the product to
be labeled, the values should be available.
2
Adjust base conveyor (s. from page 35).
3
Adjust side guidance (s. from page 37).
4
Insert label roll in the labeler (s. from page 38).
5
Adjust product light barrier (s. from page 38).
6
Adjust peeler plate of top side labeling to product (s. from page 39).
7
Adjust peeler plate of bottom side labeling to product (s. from page 40).
Summary of Contents for Geset 117
Page 2: ...Blank Page ...
