6
NORTH AMERICA
Please ensure you follow the stated precautions below while carrying out the coupler and hydraulic
kit installation procedure.
SECTION 2: PRECAUTIONS
2.0 SAFETY PRECAUTIONS
•
Always use PPE (Personal Protective Equipment) when servicing, operating or maintaining
plant, machinery and its components.
•
Refer to the carrier machine “Service Manual” for correct procedures when carrying out work on
the machine. The machine service manual takes precedence over any discrepancies between
that and this installation manual.
•
Allow for hydraulic oil to cool adequately before opening or accessing any hydraulic lines.
Hydraulic lines, fittings and components can be hot which can be harmful causing severe burns.
•
Relieve the hydraulic tank pressure before accessing hydraulic lines. Refer to the carrier machine
service manual for proper procedures.
•
Ensure that the stick of the carrier machine is resting on the ground at all times – do not leave
attachments suspended in the air during service / installation.
• Check and tighten all fittings, hose connections and joints within the hydraulic quick coupler
circuit prior to activating the machine.
• Visually inspect for oil leaks tighten and adjust accordingly.
Avoid contact with hydraulic fluids
and high pressure oils – use cardboard or similar as a backing when checking for leaks.
• Oil spills are sometimes unavoidable. Contain all fluid spills with appropriate absorbent materials
and dispose accordingly. Immediately clean affected areas to minimize safety risks.
•
When operating plant and machinery keep people and property well out of harms way. Evaluate
the working environment and identify hazards. Ensure that all people involved in the installation
understand the hazards associated with this procedure.
2.1 WELDING PRECAUTIONS
•
Before commencing any welding procedures on the carrier machine ensure that the engine is
turned off and the battery supply is disconnected (refer to the carrier machine service manual).
• Ensure all surrounding areas are protected with a flame resistant covering. Clear surrounding
areas of combustible materials. Ensure you have a fire extinguisher at hand.
•
Cover highly susceptible surfaces like cylinder rods, glass windows, electrical components and
plastics to prevent spatter or heat damage.
•
Connect the ground cable (earth lead) from the welder to the component to be welded to the
carrier machine.
•
Ensure parts and surfaces to be welded are clean and prepared properly for welding.
•
Use appropriate PPE (Personal Protective Equipment) when carrying out any welding procedures.
