214 EASTERN AVE. • ANNAPOLIS, MD 21403 • USA
410-263-6700 • fax 410-268-8713 • www.weems-plath.com
E-mail: support@weems-plath.com
3/12
ANNIVERSARY 8-DAY WIND SHIP’S BELL CLOCK
Operating Instructions
To operate clock please observe the following steps:
(1) Remove plastic tube inserted in wind hole located on the face of the
clock. Tube is inserted to keep minute hand from rotating in transit.
(2) Clock will only strike when in vertical position.
(3) Bell switch is located on left hand position of face between 10 and 11
o’clock. “Fast/slow” switch is located on right hand side of face
between 12 and 1 o’clock. Simply slide switches to the left or right
for desired bell and time adjustments. Clock will run if bells are
turned on or off.
(4) To set time, rotate the minute hand clockwise only to the desired
time. Care should be taken to not touch hour hand.
(5) Wind the bell spring and main spring clockwise only. Do not exert
force, as over-winding will damage the mechanism.* Clock should
be wound every 7 days, preferably at the same time of day.
214 EASTERN AVE. • ANNAPOLIS, MD 21403 • USA
410-263-6700 • fax 410-268-8713 • www.weems-plath.com
E-mail: support@weems-plath.com
3/12
ANNIVERSARY 8-DAY WIND SHIP’S BELL CLOCK
Operating Instructions
To operate clock please observe the following steps:
(1) Remove plastic tube inserted in wind hole located on the face of the
clock. Tube is inserted to keep minute hand from rotating in transit.
(2) Clock will only strike when in vertical position.
(3) Bell switch is located on left hand position of face between 10 and 11
o’clock. “Fast/slow” switch is located on right hand side of face
between 12 and 1 o’clock. Simply slide switches to the left or right
for desired bell and time adjustments. Clock will run if bells are
turned on or off.
(4) To set time, rotate the minute hand clockwise only to the desired
time. Care should be taken to not touch hour hand.
(5) Wind the bell spring and main spring clockwise only. Do not exert
force, as over-winding will damage the mechanism.* Clock should
be wound every 7 days, preferably at the same time of day.
214 EASTERN AVE. • ANNAPOLIS, MD 21403 • USA
410-263-6700 • fax 410-268-8713 • www.weems-plath.com
E-mail: support@weems-plath.com
3/12
ANNIVERSARY 8-DAY WIND SHIP’S BELL CLOCK
Operating Instructions
To operate clock please observe the following steps:
(1) Remove plastic tube inserted in wind hole located on the face of the
clock. Tube is inserted to keep minute hand from rotating in transit.
(2) Clock will only strike when in vertical position.
(3) Bell switch is located on left hand position of face between 10 and 11
o’clock. “Fast/slow” switch is located on right hand side of face
between 12 and 1 o’clock. Simply slide switches to the left or right
for desired bell and time adjustments. Clock will run if bells are
turned on or off.
(4) To set time, rotate the minute hand clockwise only to the desired
time. Care should be taken to not touch hour hand.
(5) Wind the bell spring and main spring clockwise only. Do not exert
force, as over-winding will damage the mechanism.* Clock should
be wound every 7 days, preferably at the same time of day.
214 EASTERN AVE. • ANNAPOLIS, MD 21403 • USA
410-263-6700 • fax 410-268-8713 • www.weems-plath.com
E-mail: support@weems-plath.com
3/12
ANNIVERSARY 8-DAY WIND SHIP’S BELL CLOCK
Operating Instructions
To operate clock please observe the following steps:
(1) Remove plastic tube inserted in wind hole located on the face of the
clock. Tube is inserted to keep minute hand from rotating in transit.
(2) Clock will only strike when in vertical position.
(3) Bell switch is located on left hand position of face between 10 and 11
o’clock. “Fast/slow” switch is located on right hand side of face
between 12 and 1 o’clock. Simply slide switches to the left or right
for desired bell and time adjustments. Clock will run if bells are
turned on or off.
(4) To set time, rotate the minute hand clockwise only to the desired
time. Care should be taken to not touch hour hand.
(5) Wind the bell spring and main spring clockwise only. Do not exert
force, as over-winding will damage the mechanism.* Clock should
be wound every 7 days, preferably at the same time of day.
