278
CHAPTER 8 - CFW-09 OPTIONS AND ACCESSORIES
Board Devicenet
Board Profibus DP
Board CC9
Section AA
A
A
M3x8 Bolt
Torque 1Nm
Figure 8.35
- Installation of the electronic board of the Fieldbus
The communication board that forms the Fieldbus Kit is installed directly onto
the CC control board, connected to the XC140 connector and fixed by spacers.
NOTE!
Follow the Safety Notices in chapter 1.
If a Function Expansion Board (EBA/EBB) is already installed, it must
be removed provisionally. For the frame size 1 you must remove the
lateral plastic cover of the product.
1. Remove the bolt from the metallic spacer near to the XC140 (CC9)
connector.
2. Connect carefully the pin connector of the Fieldbus board to the female
connector XC140 of the CC9 control board. Check the exact
coincidence of all pins of the XC140 connector (refer to figure 8.35).
8.12.1 Installation of the
Fieldbus kit
NOTE!
The chosen Fieldbus option can be specified in the suitable field of the
CFW-09 coding.
In this case the CFW-09 will be supplied with all needed components already
installed in the product. For later installation you must order and install the
desired Fieldbus kit (KFB).