2
CFW-11M RB |2-11
General Instructions
In order to open the box:
1. Put the control set box on a table with the help of two people; for the power units put the box on the
floor.
2. Open the wood crate.
3. Remove all the packing material (the cardboard or styrofoam protection) before removing the converter.
Check the following items once the converter is delivered:
;
Verify that the product identification label corresponds to the model number on your purchase order.
;
Inspect the product for external damage during transportation.
In case of any damage, immediately report it to the carrier responsible for delivering your product.
If the products are not installed immediately, store them in a clean and dry place (temperature between
-25 °C (-13 °F) and 60 °C (140 °F)) with a cover to prevent the contamination with dust.
ATTENTION!
Capacitor reforming is required if the converter or power units are stored for long periods of time
without power. Refer to the procedures in item 6.5 - table 6.3.
Figure 2.14 -
Do not tilt the power units
