KEYPAD (HMI) AND BASIC PROGRAMMING
Initialization Mode
It is the initial status of the HMI after the successful power-up (without
fault, alarms or undervoltages).
Press key
to go to level 1 of the setting mode - selection of
parameters. Pressing any other key also change to the setting mode.
Initialization
Setting
level 1
Setting
level 2
Setting Mode
Level 1:
This is the first level of the setting mode. The number of the parameter
is shown on the main display.
Use keys
and
to find the desired parameter.
Press key
to go to level 2 of the setting mode - change of the
parameter values.
Level 2:
The parameter value is shown on the main display.
Use keys
and
to configure the new value for the selected
parameter.
Press key
to confirm the modification (save the new value). After
confirming the modification, the HMI returns to level 1 of the setting
mode.
Figure 4.3:
HMI operating modes
✓
NOTE!
When the inverter is in the fault state, the main display indicates the number of the fault in the format
Fxxx
. Navigation is allowed after activation of key
.
✓
NOTE!
When the inverter is in the alarm state, the main display indicates the number of the alarm in the
format
Axxx
.The navigation is allowed after the activation of key
; thus, the indication
“A”
goes to
the unit of measurement display until the situation causing the alarm is solved.
✓
NOTE!
A list of parameters is presented in the quick reference of the parameters. For further information
about each parameter, refer to the CFW320 programming manual.
26 | CFW320
