English
HMI
Main
Level 0
Level 1
Status
Diagnostics
Configurations
Assistants
0.
0.
1.
2.
3.
Figure 4.2:
HMI Screens and Menus
Level 0:
The main screen is located, where you can select which reading variables (
Status
) you want to view.
Level 1:
The main menus to access the variables are located. These, in turn, are divided into reading variables (
Status
and
Diagnostics
), and writing or programming variables (
Configurations
and
Wizards
).
✓
NOTE!
The
Status
parameters cannot be changed through the HMI. Some of these parameters may be a
reading variable from a
Configuration
for a given communication network and thus can be changed
using it.
4.1 MAIN SCREEN
After powering up the CFW900, the HMI starts up on the
Main
screen, where you can see some reading variables
(
Status
).
Run
LOC 1800rpm 00:00
1800
3.5
60.0
rpm
A
Hz
Time indication
Speed indication
of the motor in rpm
S2.1.3
Motor direction of
rotation indication
CFW900 status
S1.1.1
Screen 1, 2, 3
LOC or REM
indication
Motor speed, current
and frequency
status parameters
Figure 4.3:
Main screen data
There are three main screens, which can be configured to display up to nine variables each. To customize these
main screens, see the section 4.5 of this chapter.
48 | CFW900
Summary of Contents for CFW900
Page 2: ......
