5
DETAILED PARAMETER DESCRIPTION
✓
NOTE!
This parameter can be changed only with the motor stopped.
P0204 - Load/Save Parameters
Adjustable range:
0 to 5
Factory setting:
0
Acesso:
Menu
→
Configurations
→
Backup
Description:
Parameters P0295 (Inverter rated current), P0296 (Inverter rated voltage), P0308 (Serial address) and P0201 (Lan-
guage selection) will not be changed when P0204 = 5 (Load WEG 60 Hz: It reset all the parameters to the 60
Hz factory default values.).
Factory
setting
(WEG standard)
P0204 = 5
Inverter
current
parameters
Figure 5.22:
Parameter transference
Table 5.20:
Load/Save Parameters
Function
0
Not Used
1
Not Used
2
Not Used
3
Reset P0043: It resets the enabled time counter.
4
Reset P0044: It resets the MWh counter.
5
Load WEG 60 Hz: It reset all the parameters to the 60
Hz factory default values.
✓
NOTE!
This parameter can be changed only with the motor stopped.
P0206 - Auto-reset time after fault
Adjustable range:
0 to 255 s
Factory setting:
0 s
Acesso:
Menu
→
Configurations
→
Protections
Description:
In the event of a fault trip the inverter can initiate an automatic reset after the time given by P0206 has elapsed.
If P0206
≤
2 auto-reset will not occur.
After the auto-reset if the same fault is repeated three times consecutively, then the Auto-Reset function will
be disable.
A fault is considered consecutive if it happens again within 30 seconds after an auto-reset. Therefore, if an
error occurs four consecutive times, it will be permanently indicated and the drive will be disabled (in such case
a reset command becomes necessary. E.g.: HMI, DI, serial, etc).
P0208 - Reference scale factor
Adjustable range:
1 to 18000
Factory setting:
1800
Acesso:
Menu
→
Configurations
→
Control
MVW3000 | 5-32
Summary of Contents for MVW3000 Series
