800043-02 Rev. A
Page 5 of 6
July 21, 2004
Main-level Screens
Second-level Screens
IP Address Selection
Press the
ENT
key and then press the arrow keys to change the IP address. Press
the
ENT
key to confirm the selection.
Press the
4
4
key to go to the Netmask Selection.
Press the
ESC
key to go to IP Setup.
Netmask Selection
Press the
ENT
key and then press the arrow keys to change the Netmask. Press the
ENT
key to confirm the selection.
Press the
4
4
key to go to Gateway Selection.
Press the
3
3
key to go to IP Address Select.
Press the
ESC
key to go to IP Setup.
IP Setup
Press the
ENT
key to go to IP Address Selection.
Press the
4
4
key to go to the Reset Unit Screen.
Press the
3
3
key to go to Front Panel Timeout.
Press the
ESC
key to go to the Home Screen.
Gateway Selection
Press the ENT key and then press the arrow keys to change the Gateway. Press the
ENT key to confirm the selection.
Press the
4
4
key to go to Reset Unit.
Press the
3
3
key to go to Netmask Selection.
Press the
ESC
key to go to IP Setup.
Reset Unit
Press the
ENT
key to go to the second-level Reset Unit Screen.
Press the
3
3
key to go to IP Setup.
Press the
ESC
key to go to the Home Screen.
2
nd
-level Reset Unit
Press the
ENT
key to reset the unit and start the boot loader.
Press the
ESC
key to go to the Reset Unit Screen.
Web Browser User Interface
In addition to the front panel, the user may control and monitor the unit using the rear-panel Ethernet connection. Before using the Ethernet connection, the appropriate
IP address, netmask, and gateway must be selected via the front-panel interface. There are two basic methods of using the Ethernet connection – with a directly
connected PC or with a LAN connection.
Locally connected PC –
Connect the DTV720 Ethernet connection to the Ethernet network connector on the PC using a crossover RJ-45 cable (8 pins).
Set the DTV720 IP Setup as follows: IP Address: 172.016.100.020
Netmask: 255.255.000.000
Gateway: 000.000.000.000
Set the PC IP address as follows:
1
IP Address: 172.016.100.001
Subnet Mask: 255.255.000.000
Connect to the DTV720 using the web browser instructions below.
LAN Connection –
Connect the DTV720 Ethernet connection to the LAN using a normal RJ-45 cable (8 pins). Set the DTV720 IP Address, Netmask, and Gateway as directed by your
network administrator. Use any PC on the LAN to connect to the DTV720 using the web browser instructions below.
1
To change the PC IP address, go to the Settings, Control Panel and double click the Network icon. Select Configuration, TCP/IP protocol, and click the Properties box.
Click Specify IP Address and set the IP Address and Subnet Mask as indicated. Click OK to restart the PC with the new values.
R e s e t U n i t . . .
P r e s s < E N T >
R e s e t U n i t . . .
I P A d d r e s s :
0 0 0 . 0 0 0 . 0 0 0 . 0 0 0
I P S e t u p . . .
N e t m a s k :
2 5 5 . 2 5 5 . 0 . 0
G a t e w a y :
0 . 0 . 0 . 0
