15
10.
After adjustment, repeat steps 4-6, and then continue cutting sod. Hold the handle bar firmly
to avoid shaking.
11.
For turning the machine during traveling, hold the handle bar firmly and lift it until rear wheels
raise from the ground.
12.
Stopping cutting sod,
●
Lift up the handle bar during cutting operation, until the blade moves to sod surface;
●
Shift the gear selecting lever to neutral to disengage the driving wheels;
●
Shift the blade lever to disengaging position to stop the blade.
●
Lift the High-adjustment and turn the Blade-c ontrolling handle to raise blade from working
surface.
WARNNING: DO NOT CUTTING THE SOD WHEN THE MACHINE IS SET IN HIGH SPEED
GEARS.
9.1.
Adjusting blade angle: Turn and release
controling lever to desired blade angle,
9.2.
Adjusting cutting depth:
Adjust blade angle
Blade controling lever
Lower locking lever
Lossen
Tight
1) For precise adjustment, set blade angle and keep the solt "A" in vertical direction.
2) Turn star knob to release the locating block.
3) Turn and release upper locking lever.
4) Turn the blade controling lever according to the graduated scale, till to your desired
5) Slide the locating block along slot "B" to contact the blade controling lever, and then
The locating block is used to indicate different cutting depth and lock frequently used
position, If you need to change your machine from transportating state to last time operat-
ting state, you only need turning the blade controling lever to contact the locating block
and then relock upper locking lever.
cutting depth, and then relock upper locking lever.
lower locking lever, and then turn blade
then relock lower locking lever.
Ｓｈａｌｌｏｗ
Ｕｐｐｅｒ ｌｏｃｋｉｎｇ ｌｅｖｅｒ
A
B
Star Knob
Deep
Blade controling lever
Locating block
Lossen
Tight
relock star type knob.
