26
AIR FILTER
Your engine will not run properly and may be damaged by using a dirty air filter. Clean the
element after every 25 hours of operation, or more often if chipper/shredder is used in very dusty
or dirty conditions. See the Maintenance section of your engine manual.
MUFFLER
Inspect the muffler regularly and replace a corroded muffler, as it could create a fire hazard and/or
cause damages.
SPARKPLUG
Change your sparkplug each year to make sure your engine starts more easily and runs better.
Set the sparkplug gap at 0.7-0.8 mm.
Troubleshooting
Often, small problems can occur in daily operation of any machine. The following
troubleshooting guide aims to address common issues and offer suggestions on how to correct
such problems.
Please review this guide before requesting service. Small problems can often be fixed
simply by following these guidelines. If there are any further questions or concerns, please do not
hesitate to contact your local dealer for assistance!
Problem
Suggested solutions
B
lade connecting rod
broken
1. Clean and make sure the drive shaft or transmission structure is free of
any winding material.
2.
Contact your local dealer
The blade still
cutting after shifting
to disengaging
Contact your local dealer
The blade does not
working
1.
Make sure the blade is engaging
2. Check the belt tensional pulley system and adjust it on request.
3. Check the belt is in good place and no winding, make sure the belt is
properly tensioned.
4. Check the clutch cable is in good place or adjusting it on request.
5.
Contact your local dealer
Excessive vibration
Poor cut- uneven
1. Check if the rear wheel bracket, handle bar and spring are assembled
properly, if all fasteners is tightened securely. Adjust any components on
request.
2.
Check if the blade-controlling handle is properly set and if the blade
components are loosen and need readjusting.
3.
Make sure the machine has select low speed gear for cutting.
4.
Make sure all locking lever locked securely.
