8
7.
Lubricate both axles on the Top Frame (55). Slide
the Right Arm (48) onto the right axle.
Note: Be
careful not to confuse the Right Arm with the
Left Arm (47); refer to step 6 to identify the
Right Arm. Be sure that the upper end of the
Right Arm is behind the indicated bracket on
the Top Frame.
Tap two 1” Retainers (63) and a 1” Round Cover
Cap (62) onto the right axle.
Be sure that the
teeth on the Retainers bend toward the Cover
Cap, as shown in the inset drawing.
Attach the Left Arm (47) in the same manner.
Press 1 3/4” Square Inner Caps (44) into the
lower ends of the Right and Left Arms (47, 48).
Wet the lower end of each Arm with soapy water.
Slide a Foam Pad (45) onto the lower end of
each Arm.
7
Bracket
Lubricate
Axle
45
47
55
48
45
44
63
62
63
55
62
CABLE ASSEMBLY
8
9
23
58
55
16
25
Hook
Ball
15
58
8.
During steps 9 through 22, refer to the CABLE
DIAGRAM on page 20 of this manual to verify
proper cable routing. Before beginning this sec-
tion, identify the Short Cable (23) and the Long
Cable (58) by comparing the lengths and the
ends of the cables.
IMPORTANT: While assembling the cables, do
not overtighten the bolts and nuts securing
the pulleys; the pulleys must turn freely.
9.
Locate the Long Cable (58).
Route the Long
Cable around a 3 1/2” Pulley (15).
Using a 3/8” x 3 1/2” Bolt (16) and a 3/8” Nylon
Jamnut (25), attach the 3 1/2” Pulley (15) to the
Top Frame (55) in the indicated location.
Be sure
that the end of the Cable with the ball is on
the indicated side of the Pulley and that the
Cable is between the Pulley and the hook on
the Top Frame.
