8
7. Attach the Backrest Tubes (5) to the Backrest
(6) with four M6 x 38mm Screws (30) and four
M6 Washers (26);
do not tighten the Screws
yet.
8. Insert the Backrest Support (7) into a set of
holes in the Uprights (1). Rotate the Backrest
Support to the locked position, with the locking
pin wrapped around the left Upright.
Apply grease to an M10 x 137mm Bolt (36).
Attach the Backrest Tubes (5) to the welded
tube on the Frame (2) with the Bolt, two M10
Washers (34), and an M10 Locknut (33).
Do
not overtighten the Locknut; the Backrest
Tubes must pivot easily.
See steps 1–4.
Tighten the M8 Locknuts (17).
See step 7.
Tighten the M6 x 38mm Screws
(30).
7
5
30
26
26
30
6
8
Grease
34
5
36
7
1
2
Welded
Tube
1
Locking
Pin
33
34
6. Insert a Long Pad Tube (10) into a hole in the
Leg Lever (4). Slide two Foam Pads (23) onto
the Long Pad Tube.
Attach the other Long Pad Tube (10) and
Foam Pads (23) in the same way.
10
10
4
23
23
23
23
6
All manuals and user guides at all-guides.com
