16
41.
Remove the preattached 90mm Pulley (not
shown) from the “U”-bracket (64).
Attach the end of the Leg Lever Cable (75) to the
“U”-bracket (64) with an M8 Washer (90) and an M8
Nylon Locknut (86).
Note: Do not completely
tighten the Locknut; it should be threaded only
two turns onto the end of the Cable, as shown
in the inset drawing.
42.
Locate the Swivel Low Cable (72), which is the
only remaining cable that has an eyelet on one
end and a ball on the other end. Route the eyelet
end of the Cable through the cage on the Long
Base (106) and through the Swivel Upright (5) as
shown.
Make sure the Cable is over the short
bar in the cage.
Attach a 90mm Pulley (78) to the indicated bracket
on the Long Base (106) with M10 x 45mm Bolt (93)
and an M10 Nylon Locknut (87).
Make sure the
Cable is in the groove of the Pulley.
43. Wrap the Swivel Low Cable (72) under a 90mm
Pulley (78). Attach the Pulley to the indicated brack-
et on the Long Base (106) with an M10 x 45mm
Bolt (93) and an M10 Nylon Locknut (87).
39
40
41
42
92
64
75
78
90
72
87
62
93
86
43
75
91
91
87
3
119
113
106
78
Cage
93
87
5
72
106
93
78
87
75
39. Route the Leg Lever Cable (75) under a 115mm
Pulley (119). Attach the Pulley and a Large Cable
Trap (113) to the indicated side of the Butterfly
Upright (3) with an M10 x 95mm Bolt (92), two M10
Washers (91), and an M10 Nylon Locknut (87).
Make sure that the Large Cable Trap is turned to
hold the Cable in the groove of the Pulley.
40. Wrap the Leg Lever Cable (75) over a 90mm Pulley
(78). Attach the Pulley to the Double “U”-bracket
(62) with an M10 x 45mm Bolt (93) and an M10
Nylon Locknut (87).
75
86
