24
TROUBLE-SHOOTING AND MAINTENANCE
Inspect and tighten all parts each time you use the training system. Replace any worn parts immediately. The
training system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the training system, can stretch slightly when it is first used. If there is
slack in the cables before resistance is felt, the cables should be tightened. If any slack is felt when using the
weight stack closest to the ab upright, both the High Cable (84) and the Ab Cable (85) will need to be tightened.
If any slack is felt when using the other weight stack, the Rear Cable (86), the Press Cable (87), and the
Butterfly Cable (88) will need to be tightened.
To tighten the cables, first insert the weight pin into the mid-
dle of the weight stack. Slack can be removed from these
cables several ways:
¥
See drawing 1.
Tighten the 1/4Ó Nylon Locknut (44) that
connects the end of the Press Cable (87) to the Large ÒUÓ
Bracket (83).
¥
See drawing 1.
Remove the 3/8Ó Nylon Locknut (42) and
the 3/8Ó x 2Ó Bolt (50) from the Cable Trap (80), 3 1/2Ó
Pulley (82), and Large ÒUÓ Bracket (83). Reattach the
Pulley and Cable Trap to the lower hole in the Large ÒUÓ
Bracket. Be sure that the Cable Trap is in the proper
position and that the Cable and Pulley move smoothly.
¥
See drawing 2.
Tighten the 1/4Ó Nylon Locknut (44) that
connects the end of the High Cable (84) to the Small ÒUÓ
Bracket (32).
The Rear Cable (86) can be tightened in the same
manner.
¥
See Drawing 3.
If you feel additional slack while using
the training system, the Ab Cable (85) and the Press
Cable (87) can be tightened further.
Remove the 3/8Ó x 2Ó Bolts (50), the 3/8Ó Nylon Locknuts
(42), the 3 1/3Ó Pulleys (82), and the Cable Traps (not
shown) from the Pulley Plates (31). Reattach the upper
Pulley
without the Cable Trap
. Reattach the lower
Pulley to the higher hole in the Pulley Plates
without the
Cable Trap
. Keep the Cable Traps for future use. Be sure
that the Cable and Pulley move smoothly.
Do not over tighten the cables. If the cables are over
tightened, the top weight will be lifted off the weight
stack.
If a cable tends to slip off the pulleys often, it may have
become twisted. Remove the cable and re-install it.
If the cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.
83
32
32
80
82
44
44
44
87
42
86
84
85, 87
82
82
31
42
50
2
3
1
50
Summary of Contents for 9300 PRO
Page 27: ...27 NOTES...
