8
6. Identify the Right Link Arm (10), which is
marked with a “Right” sticker. Apply a small
amount of grease to the axles on the Right Link
Arm and to two 5/8" Wave Washers (102).
Then, slide a Pivot Spacer (71) and a Wave
Washer onto each axle.
At the same time, slide the Right Link Arm (10)
into the right Upper Body Arm (12) and into the
Right Pedal Arm (8).
Attach the Right Link Arm (10) to the right
Upper Body Arm (12) with a 5/16" x 1" Patch
Screw (81), a Large Axle Cover (94), and a
5/16" Washer (104).
Then, attach the Right Link Arm (10) to the
Right Pedal Arm (8) with a 5/16" x 1" Patch
Screw (81), a Small Axle Cover (67), and a
5/16" Washer (104).
Tip: If you have a hard time working the
Right Link Arm (10) all the way into the right
Upper Body Arm (12) and the Right Pedal
Arm (8), try working it in halfway and then
tightening the 5/16" x 1" Patch Screws (81)
to pull it the rest of the way in.
Repeat this step on the other side of the
elliptical exerciser.
6
10
67
81
12
71
102
8
Grease
Grease
5
5. Identify the Right Pedal Plate (107), which is
marked with an “R” sticker.
Attach the Right Pedal Plate (107) to the Right
Pedal Arm (8) with three M10 x 20mm Patch
Screws (108) and three M10 Split Washers
(110).
Identify the Right Pedal Assembly (62), which is
located in a package marked with a “Right”
sticker.
Attach the Right Pedal Assembly (62) to the
Right Pedal Plate (107) with five #10 x 1/2"
Screws (79), five M6 Split Washers (111), and
five #10 Fender Washers (80).
Tip: To avoid
damaging the Pedal, do not overtighten the
Screws.
Repeat this step for the Left Pedal Plate (not
shown) and the Left Pedal Assembly (56).
80
62
108
107
56
79
79
8
110
111
102
104
81
104
94
71
Summary of Contents for Black 100 Xpb Elliptical
Page 23: ...23 NOTES...
