6
1.
Press a 63mm Round Cap (40) onto the Left
Base (1).
Attach a Foot (42) to the Left Base (1) with an
M4 x 20mm Screw (71). Next, tighten a
Leveling Foot (41) into the Left Base.
Repeat this step for the Right Base (2).
1
1
71
42
2
41
40
ASSEMBLY
To make assembly easier, carefully read the
following assembly tips:
•
To hire an authorized service technician to
assemble the weight bench, call 1-800-445-2480.
•
Assembly requires two persons.
•
Because of its weight and size, the inversion
system should be assembled in the location
where it will be used. Make sure that there is
enough clearance to walk around the inversion
system as you assemble it.
•
Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
•
For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
• The included grease and the following tools (not
included) may be required for assembly:
two adjustable wrenches
one rubber mallet
one standard screwdriver
one Phillips screwdriver
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Before beginning assembly, make sure
that you understand the information in
the box above.
2. Attach the Left Base (1) to the Right Base (2)
with two M10 x 80mm Button Bolts (52), four
M10 Curved Washers (50), and two M10
Locknuts (65).
Attach another Foot (42) to the Right Base (2)
with an M4 x 20mm Screw (71).
2
2
1
52
50
50
65
71
42
