4
ASSEMBLY
Assembly requires two persons.
Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own rubber mallet .
Use the drawings below to identify the hardware used during assembly.
Note: If a part is not in the parts bag,
check to see if it has been preattached to one of the parts to be assembled. To avoid damaging plastic
parts, do not use power tools for assembly.
1. Attach the Base Crossbar (44) to the two
Upright Bases (16) with two M10 x 50mm
Screws (15) and two 10mm Washers (14) as
shown.
44
14
15
16
16
14
15
1
M10 Washer
(14)–10
M10 Nut (18)–10
M6 x 15mm
Screw (4)–2
M12 x 60mm Screw (11)–2
M10 x 55mm Screw (13)–4
M10 x 50mm Screw (15)–2
M12 Washer
(12)–2
