8
14
13
34
29
27
28
26
39
12. Locate the Long Cable (34); note that there is a
single ball on one end of the Long Cable and a
metal sleeve on the other end.
Route the metal-sleeve end of the Long Cable
(34) up under the lat bar rest on the Weight
Frame (10) and over a 3 1/2” Pulley (27). Attach
the Pulley to the Weight Frame with an M10 x
75mm Bolt (31), two Short Spacers (32), two M10
Washers (24), and an M10 Nylon Locknut (26).
14 Wrap the Long Cable (34) around a 3 1/2” Pulley
(27) as shown. Attach the Pulley and a Cable
Trap (39) to the Pulley Plates (28) with an M10 x
45mm Bolt (29) and an M10 Nylon Locknut (26).
13. Route the Long Cable (34) over a 3 1/2” Pulley
(27) and down through the Weight Frame (10).
Attach the Pulley to the Weight Frame with an
M10 x 75mm Bolt (31), two Short Spacers (32),
two M10 Washers (24), and an M10 Nylon
Locknut (26).
31
24
27
24
26
32
32
34
10
Lat Bar
Rest
31
24
27
24
26
32
32
34
10
12
2
1
15
16
35
11. Insert the two Safety Spotters (16) into a set of
adjustment holes in the left and right Uprights (1, 2).
Wrap the locking pins around the Front Uprights.
Insert a 1” Round Inner Cap (35) into the end of
each Weight Rest (15).
Insert the two Weight Rests (15) into a set of
adjustment holes in the Front Uprights (1). Wrap
the locking pins around the Front Uprights.
Tighten all of the M10 Nylon Locknuts (26)
used in steps 1–10.
11
