10
19. Attach a Pulley Housing (94) to the indicated “U”-
channel on the 10-Pound Center Crossbow (44)
with a 3/8” x 4” Bolt (66) and a 3/8” Nylon
Locknut (76).
Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley inside of the Pulley
Housing (94) with a 3/8” x 1 1/2” Button Head
Bolt (71) and a 3/8” Nylon Jamnut (103).
19
66
94
28
80
44
103
76
71
18. Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley and a Pulley Guard (29) to
the indicated 3/8” x 5 1/2” Carriage Bolt (73) with
a 3/8” Nylon Locknut (76).
Be sure the flat edge
of the Pulley Guard is on the side shown.
18
76
28
80
73
29
Flat
Edge
16
86
Edges
up
72
Rings on
this side
96
95
95
44
36
67
35
35
4
17.
Locate the Long Cable (80).
Insert one end of
the Cable through the welded tube on the indicat-
ed end of the Cross Tube (11) and then through a
Swivel Arm (22). If necessary, use the tip of a
screwdriver to pull the end of the Cable out of the
Swivel Arm.
Be sure the Cable is on the indicat-
ed side of the welded rod in the Swivel Arm.
Insert the Swivel Arm (22) into the welded tube
on the Cross Tube (11). Secure the Swivel Arm
with a #8 x 3/8” Screw (24).
Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley inside of the Swivel Arm
(22) with a 3/8” x 1 1/2” Button Head Bolt (71)
and a 3/8” Nylon Jamnut (103).
17
71
22
24
28
80
11
103
Rod
“U”-Channel
16. Locate the Crossbow Spacer (35) on the Lat
Tower (4) (see the inset drawing). Remove the
two preassembled 5/16” x 3/4” Button Head
Screws (86) and the Crossbow Cover Plate (72)
from the Crossbow Spacer.
Set the Crossbows into the Crossbow Spacer (35)
in the following order: the 10-Pound Removable
Crossbow (67), the 20-Pound Removable
Crossbow (36), an 80-Pound Crossbow (95), the
10-Pound Center Crossbow (44), an 80-Pound
Crossbow (95), and the 40-Pound Crossbow (96).
Make sure the indicated rings are on the side
shown and the arrows point toward the Spacer.
Reattach the Crossbow Cover Plate (72), with the
the edges up, to the Crossbow Spacer (35) with
two 5/16” x 3/4” Button Head Screws (86).
