15
30
31
1
Crossbows
6
7
3
43
44
4
“U”-Channel
“U”-Channel
80
10
13
STORING THE RESISTANCE SYSTEM
To store the resistance system, slide the ends of the
Leg Lever Cable (32) onto the hook on the bottom of
the Bench Rail (5). Be sure the Seat (13) is in the
position closest to the Front Leg (6) (see ADJUSTING
THE SEAT on page 13). Next, remove the Storage
Knob (30) from the Upright (3). Lift the Front Leg
toward the Lat Tower Crossbar (10), and tighten the
Storage Knob into the side of the Upright and the
Bench Rail. Remove all of the crossbows from the
“U”-channels on the 10-Pound Center Crossbow (44)
(see ADJUSTING THE RESISTANCE on page 14).
Finally, loosen the Fulcrum Knob (43) and pull it out
as far as it will go. Turn the crossbow assembly verti-
cally and engage the Fulcrum Knob into the fulcrum
on the Lat Tower (4).
Note: Storing the crossbows
vertically will prolong the life of the crossbows.
To move the resistance system, place the toe of your
shoe on the end of the Base (1) and hold the resist-
ance system in the indicated area. Tilt the resistance
system back onto the Wheels (31) and roll it to the
new location.
Be careful not to let the Front Leg (6)
or Leg Lever (7) pinch your hands when you tilt
the system back.
WARNING:
Be sure that all of the
crossbows are removed from the “U”-channels
before moving the crossbow assembly to the
stored position.
Make sure that the crossbow assembly is in
the horizontal position and that the Storage
Knob (30) is in place and fully tightened each
time you use the resistance system.
32
14
15
12
13
Rod
Slot
5
12
6
3
ADJUSTING THE BACKREST
The Backrest (14) can be used in a level position or
any of three inclined positions. To use the Backrest in
a level position, secure the Seat Carriage (12) to the
adjustment hole in the Bench Rail (5) next to the Front
Leg (6) (see ADJUSTING THE SEAT on page 13).
To use the Backrest (14) in an inclined position,
secure the Seat Frame (12) to one of the other three
adjustment holes in the Bench Rail (5). Rest the
Backrest against the Upright (3).
For row exercises, remove the Backrest (14). Hold
the Backrest vertically over the Seat (13) and lift the
rod out of the slot in the Seat Carriage (12) (see the
inset drawing).
Stored Position
Hook
Hold in
this area
5
