7
2.
Insert the connector of the Lower Wire Harness
(113) into the socket of the Upper Wire Harness
(71).
The connector should slide easily into the
socket and snap into place. If the connector does
not slide easily and snap into place, turn the con-
nector over and then insert it.
Make sure that the connector and wires appear
as shown in the inset drawing.
IF THE CONNEC-
TOR IS NOT INSERTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE POWER
IS TURNED ON.
Insert the Mech Frame (6) into the Base Plate (1).
Attach the Mech Frame to the Upright (2) with a
1/2” x 25mm Screw (85) and a 1/2” Lock Washer
(12).
Do not tighten the Screw yet.
Attach the Mech Frame (6) to the Base Plate (1)
with four M10 Nylon Locknuts (103).
Tighten the 1/2” x 25mm Screw (85).
2
12
6
103
103
71
113
85
2
1
3.
Press the Rail Cap (49) onto the Leg (5). Attach
the Leg to the Rail (4) with two M10 x 64mm
Button Bolts (80), four M10 Washers (106), and
two M10 Nylon Locknuts (103).
3
4
49
103
5
106
106
80
Holes on
this side
106
106
29
28
103
4.
Lubricate an M10 x 125mm Button Bolt (89) with
grease. Attach the Rail (4) to the Row Plate (28)
with the Bolt, two M10 Washers (106), two 31mm
Spacers (30), and an M10 Nylon Locknut (103).
Do not overtighten the Locknut; the Rail must
be able to pivot easily.
Tighten the Storage Knob (29) into the Row Plate
(28) and the Rail (4).
4
89
30
30
4
Lubricate
Black
Wire
Red
Wire
71
113
