11
16. Wrap the Butterfly Cable (47) around a 90mm Pulley
(50) in the direction shown. Attach the Pulley and two
Pulley Covers (28) to a Butterfly Pulley Bracket (26)
with an M10 x 50mm Bolt (54), an M10 Flat Washer
(62), and an M10 Nylon Locknut (60).
Make sure that
the Pulley Bracket is oriented exactly as shown.
Lubricate an M10 x 80mm Bolt (56). Attach the Butterfly
Pulley Bracket (26) to the bracket (not shown) on the
Front Upright (4) with the Bolt and an M10 Nylon
Locknut.
Slide the loop on the end of the Butterfly Cable (47)
onto the welded hook (not shown) on the semi-circu-
lar bracket behind the Right Arm (11).
16
50
60
56
26
4
60
62
11
28
28
47
54
15. Wrap the Butterfly Cable (47) around a 90mm Pulley
(50) in the direction shown. Attach the Pulley and two
Pulley Covers (28) to the Pulley Frame (27) with an
M10 x 50mm Bolt (54) and an M10 Nylon Locknut
(60).
Make sure that the small label on the Pulley
Covers is facing upward.
Important: Make sure that the Pulley Frame (27) is
oriented exactly as shown.
15
28
47
28
27
60
54
50
17. Identify the High Cable (48). It is about 236cm long
and it has a loop on one end and a ball on the other.
Route the end of the High Cable with the loop up
through the indicated slot in the Top Frame (6) from
below.
Wrap the High Cable (48) around a 90mm Pulley (50)
in the direction shown. Attach the Pulley inside the
slot in the Top Frame (6) with an M10 x 65mm Bolt
(58), two M10 Flat Washers (62), two Long Metal
Spacers (49), and an M10 Nylon Locknut (60).
17
48
6
Slot
60
50
62
49
62
Lubricate
58
All manuals and user guides at all-guides.com
all-guides.com
