15
29
79
80
78
78
23
74
19
23
74
7
31. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENT, beginning on page 17 of this manual.
Before using the training system, pull each cable a few times to make sure that the cables move smoothly
over the pulleys. If one of the cables does not move smoothly, find and correct the problem.
IMPORTANT: If
the cables are not properly installed, they may be damaged when heavy weight is used. If there is
any slack in the cables, you will need to remove the slack by tightening the cables. See MAINTE-
NANCE AND TROUBLE-SHOOTING on page 19.
29. Insert an M6 x 38mm Carriage Bolt (74) into the centre
hole in each Seat Plate (23). Attach each Seat Plate
to the Seat (19) with two M6 x 15mm Screws (78).
Turn the Seat (19) so the wide end is in the position
shown. Insert the two M6 x 38mm Carriage Bolts (74)
into the indicated holes in the Seat Frame (7). Secure
the Carriage Bolts with two M6 Flat Washers (80) and
two M6 Nylon Locknuts (79).
30. Press a 19mm Round Inner Cap (42) into each end of
the Long Pad Tube (83) and the Short Pad Tube (84).
Slide the Long Pad Tube (83) into the holes in the
bracket on the Seat Frame (7). Slide a Large Foam
Pad (32) onto each end of the Long Pad Tube.
Slide the Short Pad Tube (84) into the hole in the Leg
Lever (8). Slide a Narrow Foam Pad (33) onto each
end of the Short Pad Tube.
30
42
84
33
42
32
83
7
8
33
42
42
32
All manuals and user guides at all-guides.com
