6
1.
Open the parts bag labelled “FRAME ASSEMBLY.”
Press a 50mm Square Cover Cap (35) onto each end
of the Front Stabiliser (2).
Attach the Front Stabiliser (2) to the Base (1) with two
M8 x 70mm Carriage Bolts (64), a 50mm x 102mm
Support Plate (21), and two M8 Nylon Locknuts (70).
Insert two M8 x 70mm Carriage Bolts (64) through a
50mm x 102mm Support Plate (21) and then through
the indicated holes in the Base (1). Place the Base on
the floor.
1
Frame Assembly
64
21
35
70
21
2
35
1
64
2. Press a 50mm Square Cover Cap (35) onto each end
of the Rear Stabiliser (3).
Place the Rear Stabiliser (3) on the floor and line up
the holes in the Rear Stabiliser with the holes in the
bracket on the Base (1).
Press the 25mm x 50mm Cover Cap (53) onto the
indicated end of the Rear Upright (5).
Attach the Rear Stabiliser (3) and the Rear Upright
(5) to the Base (1) with two M8 x 70mm Carriage
Bolts (64) and two M8 Nylon Locknuts (70).
2
64
35
70
64
3
53
35
1
5
70
Before you begin this step, make sure that
you have read all of the information on page
5. This introduction will save you much more
time than it takes to read it!
All manuals and user guides at all-guides.com
all-guides.com
