7
3. Press a 25mm x 50mm Inner Cap (39) into the sup-
port tube on the Front Upright (4).
Slide the Front Upright (4) onto the M8 x 70mm
Carriage Bolts (64) in the Base (1). Thread an M8
Nylon Locknut (70) onto each Carriage Bolt.
Do not
tighten the Nylon Locknuts yet.
3
39
64
70
4
1
70
Support Tube
4. Place the Weight Bumpers (44) over the outer holes
in the bracket on the Base (1).
Make sure that the
flat sides of the Weight Bumpers are facing the
floor.
Insert the Weight Guides (13) into the holes in the
bracket on the Base (1).
Make sure that the Weight
Guides are turned so the indicated holes are at
the top.
Slide the nine Weight Plates (36) onto the Weight
Guides (13).
Make sure that the Weight Plates are
turned correctly—the large grooves in the Weight
Plates must be facing the floor and the adjustment
holes must be on the side shown.
Press the Adjustment Tube Cap (43) into the lower
end of the Adjustment Tube (14). Insert the
Adjustment Tube into the stack of Weight Plates (36).
Slide the Top Weight (17) onto the Weight Guides
(13).
Make sure that the groove in one side of the
Top Weight is facing the floor and that it fits over
the spring pins on the Adjustment Tube (14).
4
13
17
14
43
36
44
1
Holes
Adjustment
Holes
Spring Pin
All manuals and user guides at all-guides.com
