8.
Open the parts bag labelled “ARM ASSEMBLY.”
Insert the indicated end of the Locking Plate (29) into
the slot in the support tube on the Front Upright (4).
Lubricate an M10 x 65mm Bolt (58). Attach the
Locking Plate to the indicated hole in the support tube
with the Bolt, two M10 Flat Washers (62), and an
M10 Nylon Locknut (60).
8
9. Press two 50mm Square Inner Caps (37) into the
Butterfly/Press Frame (9) as shown. Next, press two
25mm x 50mm Inner Caps (39) into the Butterfly/Press
Frame (9).
Lubricate an M10 x 125mm Bolt (51). Attach the
Butterfly/Press Frame (9) to the indicated holes in the
Top Frame (6) with the Bolt, two 10mm Flat Washers
(62), and an M10 Nylon Locknut (60).
Make sure
that the indicated bracket is on the side shown.
Do not overtighten the Nylon Locknut; the
Butterfly/Press Frame must pivot easily.
10. Press a 45mm Square Inner Cap (38) into each end
of the Right Arm (11). Wet the lower end of the Right
Arm with soapy water and slide a Short Foam Pad
(31) onto the Right Arm.
Press a 25mm Round Inner Cap (41) into the indicat-
ed hole in the Right Arm (11). Press a 2 3/4” Plastic
Sleeve (46) onto the round tube on the Right Arm.
Attach the Right Press Handle (20) to the Right Arm
(11) with two M8 x 60mm Carriage Bolts (65), a 38mm
x 102mm Support Plate (22), and two M8 Nylon
Locknuts (70).
Press a 25mm Round Inner Cap (41) into each end of
the Right Press Handle (20). Slide a 130mm
Handgrip (30) onto each end of the Right Press
Handle.
9
10
9
Slot
60
58
4
29
62
Bracket
Lubricate
39
60
9
70
41
30
41
20
30
38
31
6
46
62
62
51
38
22
65
11
41
37
Lubricate
37
62
Arm Assembly
All manuals and user guides at all-guides.com
